3M W100, Manual

Page: 31 / 58

19
8-MAINTENANCE AND REPAIRS (continued)
8.9 Handle
To Remove:
1. Remove handle hole plug
(Figure 8-2).
2. Remove 15/16 inch nut.
3. Slide handle OFF handle shaft.
4. Rotate handle forward to about 12 inch
mark on right side cover and pull
handle gently from dispenser
(Figure 8-3).
New Part Installation:
Reverse the removal procedure above.
8.10 Handle Shaft
To Remove:
1. Remove right side cover
(See Section 8.11).
2. Remove left side cover
(See Section 8.12).
3. Remove pinch roller
(See Section 8.19).
4. Remove weighted brush cover
(See Section 8.23).
5. Remove tape channel plate
(See Section 8.25).
6. Remove idler gear
(See Section 8.29).
7. Remove drive gear and clutch assembly
(See Section 8.30).
8. Remove cutter arm springs from screws
they are resting upon
(Section 8.15).
9. Remove gearbox/motor mount
(Section 8.32).
10. Remove large e-clip from left side of
the handle shaft
(Figure 8-4).
11. Remove handle shaft from the chassis and
(if needed) insert a new handle shaft into 1/2"
bearing
(Figure 8-5).
New Part Installation:
Reverse the removal procedure above.
Figure 8-3
Figure 8-2
2011 October
WaterAct-M-S
Remove
Nut and
Slide handle
off shaft
Rotate Handle
to 12 inch
mark and
remove
Figure 8-4
Figure 8-5
E-Clip
Handle
Shaft
•
To reduce the risk associated with
pinch hazards:
−
Keep hands, hair, loose clothing, and
jewelry away from dispenser.
CAUTION