3M Tape Application Monitor, Instructions And Parts List

Page: 42 / 62

North American - ENG
Date Released:
05-22-18
TAM Application Monitor - Yype 21800
Page 36
44-0009-2048-6 / ECO# 0078483
Input Output Registers Timers Description
000 Current Sensor
001 UPPER – Low Tape Proximity Sensor
002 Photo Eye - Box Present Sensor
003 LOWER – Low Tape Proximity Sensor
004 LOWER – Tape Dispense Proximity Sensor
005 SPARE - Not in Use
006 UPPER – Tape Dispense Proximity Sensor
007 SPARE - Not in Use
500 SPARE - Not in Use (AC Voltage Common)
501 “Optional” Remote AC (120/240) Beacon Light
502 Case Sealer - Solid State Relay
503 “Optional” Dry Contact Relay. This output is used to stop an 800rks or 800rf
in the event of a fault condition. This output could also be used to halt an
external conveyor or signal a host controller. Output is normally ON and is
OFF under a fault condition.
504 SPARE - Not in Use (DC Voltage Common)
505 Panel Indicator Light 24V DC
DM0075 System Con fi guration Register (31=Lower Only, 32=Upper Only,
3=Both Taping Heads). Factory setting DM0075 = 33.
DM0080 By-Pass Register (1=By-Pass Enable, <>1 = Normal TAM Operation.
Factory setting DM0080 = 0.
DM0100 Taping Head o ff set distance (0 = Standard 1 = O ff set).
DM0105 Case Sealer Belt Speed (0=15 ips 1=20 ips 2=30 ips).
TH051 Represents the distance in “time” from the box present sensor to within ½”
from the end of the lower taping head cut-o ff bracket (i.e. just before the
tape would cut). When possible the box present sensor should be positioned
very near the lower taping head cut-o ff bracket so the value of TH051 is small.
In cases where this is not possible position the sensor just in front of the
lower taping head apply roller. However, if there is no lower taping head
used then position the box present sensor as close to the upper cut-o ff
bracket.
Note: In all cases position the sensor to trigger before the tape would cut.
As an example for a 15 ips case sealer belt speed and a box present
sensor positioned to trigger ½” before the tape would cut TH051,
would be set to 3 hundreds of a second [TH051 = distance/velocity =
(1/2/15)*100]. In applications where only an upper taping head is
used (i.e. DM0075 = 32) TH051 represents the time in hundreds of
a second from the box present sensor to just before the upper taping
head cuts. Factory Setting TH051 = 2.
Please refer to table II below for PLC inputs, outputs, special “settable” internal control registers and settable
internal timers with accompany description.
PLC Memory Map