North American - ENG
Date Released:
05-22-18
TAM Application Monitor - Yype 21800
Page 10
44-0009-2048-6 / ECO# 0078483
The taping head tape drum bracket angle must be
determined to properly position the Lower Dancer Arm
assembly. Refer to
Figures 2-6 and 2-7
to determine
which example represents the current machine
con
fi
guration.
1) Remove the lower taping head supply roll
2) Properly position the taping head inside the case
sealer
cavity.
3) Position the Lower Dancer Arm spring post in
the appropriate location. The factory spring
post
setting
(Figure 2-8)
corresponds to the
bracket angle shown in
Figure 2-6.
The spring
post must be moved
(Figure 2-8)
as the bracket
angle changes to keep the dancer arm roller in
contact with the tape drum
(Figure 2-7).
Important:
The spring post must be in the
appropriate location to determine the
correct mounting location.
4) Place and hold the lower dancer arm assembly
on the bottom of the right hand drive frame so
the dancer arm roller is in contact with the tape
drum
(Figures 2-6 and 2-7).
Note:
Right hand is de
fi
ned by viewing the machine
from the entrance end.
5) Place a mark on the case sealer frame at
the back of the dancer arm bracket
(Figure 2-6 and 2-7).
The lower dancer arm assembly is mounted directly
to the case sealer’s right hand lower drive frame using
the nut plate, M6 screws (2) and washers (2) supplied
in this kit. Mounting holes must be drilled in the lower
drive frame on all case sealer models.
Lower Dancer Arm
Note:
This kit contains components to monitor both
an upper and lower taping head on a single
case sealer. Outboard tape supply roll
mounting is possible with an optional
lower to outboard conversion kit
(See
"Options/Accessories").
Lower Dancer Arm Mounting
Figure 2-6
Figure 2-7
Place Mark Here
Spring
Post
Place Mark Here
Figure 2-8
Figure 2-9
Installation and Set-Up
(continued)
Summary of Contents for Tape Application Monitor
Page 6: ...5...
