© 3M 2010. All Rights Reserved.
15
3M™ SCP700 Series Mobile Stand
Assembly and Installation Guide
Step 4.
Using a Phillips (+) screwdriver, remove
the three screws holding the cover to
the base.
Step 5.
Lift the cover off the base and set aside.
Route Control Cable
Required with optional 3M I/O Module.
Step 1.
Feed the control cable through the arm. Secure about
6 inches (150 mm) from the end of the existing cable
bundle using a cable tie.
Step 2.
Route control cable alongside the bundled cables and
attach using cable ties.
Step 3.
Hang the folding wall mount base on the mounting
screws.
Attaching to the Stand
6”
(150mm)
Lanyard
cable ties
Step 1.
Lower the whiteboard stand to the lowest position
and lock in place.
Step 2.
Adjust the two upper mounting screws so that they
protrude approximately 3/8 in.
Step 3.
Adjust the two lower leveling screws on the
folding arm mount base so that they protrude
approximately 3/8 in.
Step 4.
Hang the folding wall mount base on the mounting
screws.
Step 5.
Install lanyard using one screw M5 x 12mm and
one washer.
Summary of Contents for SCP716W
Page 22: ...meetings mmm com ...
