© 3M 2010. All Rights Reserved.
19
3M™ SCP700 Series Mobile Stand
Assembly and Installation Guide
Prior to moving the SCP700 Series Mobile Stand, the projector arm must be in the stowed position
(fully retracted). If the arm is not in the stowed position, the projector arm will become unstable and
possibly hit the wall or the individuals(s) relocating the SCP700 Series Mobile Stand.
Step 5.
Connect the cables to the projector
according to the Quick Start Guide.
Step 6.
If using the optional accessory I/O module,
attach the cables as shown in the Quick
Start Guide.
Step 7.
Power on unit and change image size by
adjusting the arm extension in or out.
Step 8.
Adjust projector aim by loosening thumb
screw.
Audio
Power
USB
USB
Control
Signal
Audio
Out
A/C
Power
Service
Computer/
Component
Control
Safety Pin Installation
Step 1.
Support the projector arm and push the
assembly into the stowed position.
Step 2.
When the projector arm is in the full stowed
position, the safety tab will be in the “up”
position.
Step 3.
Loop the lanyard and safety pin around the
mounting knob and drape over the projector
arm.
Step 4.
Slide the safety pin all the way in through
the hole that is on the safety tab.
Step 5.
When the safety pin is secured in the safety
tab, gently release the projector arm.
Repeat these steps, in reverse order, to release the
projector arm for use.
Lanyard
Projector Base
Projector Arm
Safety Pin
Safety Tab
The optional I/O module
attaches to back of stand
using M3 x 16 mm screws.
See page 11.
To Projector
To make this adjustment, the
display board must be installed,
and the projector must be running
with the folding wall mount cover
removed.
Summary of Contents for SCP716W
Page 22: ...meetings mmm com ...
