Assembly and Installation Guide
3M™ SCP700 Series Mobile Stand
10
© 3M 2010. All Rights Reserved.
The following steps should be performed by two people.
Attaching the Back Support Assembly and Back Plate
Step 1.
Lay the base on the ground with the support poles attached.
Step 2.
Line up the support poles with the matching holes that are
located at the bottom of the back support assembly.
Step 3.
Slide the back support assembly onto the support poles.
Step 4.
Slide the unit forward until the gas shock bracket is resting
on the base between support poles.
Step 5.
Use a rubber mallet to gently hammer the gas shock base
into place between the support poles (Figure A).
Step 6.
Gently tilt the unit upright until it is resting on the base with all
four caster wheels touching the ground.
Step 7.
Install the Back Plate. Use screws M6 x 20mm to secure
plate. The plate has 3 letter markings A, B, and C. Align
holes and install four screws. Key: A=Model SCP716,
B=Model SCP712, C=Model SCP715/717/740.
Step 1.
Remove the two (2) M10 x 35mm set screws in the
base columns.
Step 2.
Place the two (2) support poles onto the base
columns.
Step 3.
The cable ports of the support poles must face the
back of the base, exposing the base columns and
set screw mounting points.
Step 4.
Once the support poles are seated firmly, install
and tighten the two (2) M10 x 35mm set screws
found on the bottom rear of the base columns to
secure the support poles to the base.
Base
Support
Poles
M10 x 35mm Set
Screw
M5 Allen
Wrench
Support Pole Installation
Support Poles
Back Plate
Gas Shock
Base
Figure A
Support Poles
Gas Shock Base
M10 x 35mm Set
Screw
A
B
C
716
712
715/717/740
Summary of Contents for SCP716W
Page 22: ...meetings mmm com ...
