Assembly and Installation Guide
3M™ SCP700 Series Mobile Stand
12
© 3M 2010. All Rights Reserved.
Parts List
Thread each leveling foot completely into the underside of the leg.
Stabilizer Legs
(Qty 2)
Allen Wrench
(Qty 2)
⅜ Leveling Feet
(Qty 2)
M8 x 20mm Set Screws
(Qty 2)
M8 x 12mm Set Screws
(Qty 2)
5
32
M5
M8 x 16mm Hex Head Screw
(Qty 4)
Step 1
The mobile cart must be assembled prior to attaching the stabilizer legs.
Step 2
Slide the two (2) stabilizer
legs together and align the
elongated holes.
Allow for a slight degree of
lateral (side-to-side) movement
around the support poles.
Insert and ngertighten four
(4; two per side) M8 hex head
screws. Use an M5 Allen
wrench to thread in the M8 hex
head screw.
The two stabilizer legs should
be level with each other prior to
tightening.
Tighten the M8 hex head
screws using the M5 Allen
wrench.
Do not overtighten the M8 hex
head screws.
M8 x 12 Set Screw
(
5
32
Allen Wrench)
Step 3
M8 Hex Screw
(M5 Allen Wrench)
Level
Slide the stabilizer legs down
until they are resting on the
base.
Make sure the stabilizer legs are
sitting at on the base before
inserting the set screws.
Insert two (2) M8 x 12 set screws
into the front mounting points of
the stabilizer legs.
Insert two (2) M8 x 20 set screws
into the rear mounting points of
the stabilizer legs.
The sets screws will go inside
the cable port on the back of the
support poles.
Tighten the M8 set screws using
the
5
32
Allen wrench.
Adjust the feet levelers to ensure
the base is level.
M8 x 20 Set Screw
(
5
32
Allen Wrench)
Front
Rear
Install Center Stabilizer Legs
Installation Instructions: 9533-021-E03-00
Visit 3M web site at http://www.mmm.com.com/meetings
Summary of Contents for SCP716W
Page 22: ...meetings mmm com ...
