3M Dynapro ET 3170 Terminal Series B, Installation Manual

Page: 45 / 125

3M Touch Systems Proprietary Information
9
CHAPTER 3
Installing the terminal
About this chapter
This chapter outlines:
!
How to do a typical installation of the ET 3170 terminal
!
How to connect a serial device
!
How to connect a keyboard
!
How to connect AC power
Typical installation
This section explains how to do a quick, pre-installation check of the terminal and
then outlines the steps of a typical installation procedure.
While most installations will follow these steps, your installation may differ. Read
and understand the steps below and then decide whether you need to modify the
steps to suit your application before beginning to install the terminal.
Pre-installation check
Before fully installing the terminal, run the following quick check to make sure
that the terminal is functioning properly:
1.
Attach power to the terminal using the AC power cable supplied (Figure 2).
2. Turn on power at the source and verify that the terminal powers up.
Upon power-up, the terminal should enter a Power On Self-Test (POST)
mode and run several internal tests for a few seconds. When the tests are
completed successfully, the terminal application starts and
appears on the screen
3. To check that the touch screen is functioning, press once.
A blinking cursor should appear in the top left corner of the display.
4.
If the unit performs as described, disconnect power and proceed with the
“Summary of installation steps” below. If you encountered any problems
during the pre-installation check, refer to Chapter 7, “Troubleshooting”. If
problems persist, contact 3M Touch Systems Technical Support.
Self-tests OK
Self-tests OK