![background image](http://html1.mh-extra.com/html/3m/crimplok-6702-50-50-um-mm/crimplok-6702-50-50-um-mm_instructions-manual_442851009.webp)
78-0015-0557-3-B
9
3.15
Remove the cable holder from the cleaver. Slide
the front shuttle all the way forward.
4.0 Fiber Insertion and Connector Activation
4.1
Grip the back of the cable holder. Slowly insert
the cable holder (with cleaved fiber) into the
guide track on the protrusion setting tool until it
reaches a stop.
Note: Insert the cable holder slowly to avoid breaking the
fiber. This step should take 5 seconds or more.
Faster insertion can lead to breaking the fiber. As
the fiber holder slides in, the shuttle will reach a
stop, and the cleaved end of the fiber will thread
through the connector.
4.2
The cable holder will make a click sound as it
reaches a stop. Gently pull back on the cable
holder about 1 mm, release it, and watch it spring
forward into place. This indicates you are ready
for the next step. If the cable holder did not click
or does not spring forward, see the
Troubleshooting section (7.0).
4.3
Verify that the cleaved end of the fiber extends
beyond the tip of the connector ferrule. To do this,
press and hold the push button on the flashlight
contained within the protrusion setting tool, and
visually confirm the presence of approximately 1
mm of fiber through the viewing window. If for
some reason the fiber is not seen extending
beyond the tip of the connector ferrule, withdraw
the fiber holder (with cleaved fiber) from the
protrusion setting tool and repeat as many of the
preceding steps as necessary.
1. click
2. Pull 1 mm &
release to check
spring-back
Approx. 1 mm of fiber visible.
Slow, >5 seconds