78-0015-0557-3-B
14
5.5
Rotate the input knob one full turn with a single
continuous motion. It automatically stops after one
full turn.
5.6
Remove the connector from the port on the finisher
lid.
Note: The 3M™ Nano Finishing Tool is best stored dry –
inside and out. Open the lid as shown in step 5.1,
and allow to dry.
5.7
Remove the lapping film. Inspect the lapping film for fiber tracks. If the film has tracks, dispose of it. If not,
restart at step 5.1. one full turn.
APC
UPC
5.8
Dry the connector using a new lint-free wipe. Do
not use the same wipe used for stripping fiber. Fold
the wipe to provide cushion. For APC, tilt the
connector so the ferrule tip is in full contact with
the wipe. For UPC, hold the connector
perpendicular to the wipe. Press the ferrule tip into
the wipe slightly and move the tip in a circular
motion. After the connector has been dried, add 1
or 2 drops of alcohol or cleaning fluid to a clean
area of the wipe. Do not mix water and alcohol or
water and cleaning fluid on the wipe. If too much
alcohol or cleaning fluid soaks the wipe, just use
the edge of the wetted area. Clean the connector by
moving the tip in a small circular motion. Then dry
the connector with a spot on the wipe that has not
been used yet, and is not contaminated with water,
alcohol or cleaning fluid. Use a small circular
motion. Finish with a twisting motion.
Remove connector
& clean
1. Dry off water
2. Clean with alcohol
or cleaner
3. Dry off & twist