![background image](http://html1.mh-extra.com/html/3m/crimplok-6702-50-50-um-mm/crimplok-6702-50-50-um-mm_instructions-manual_442851010.webp)
78-0015-0557-3-B
10
4.4
Rotate the activation lever on the protrusion
setting tool 180° until the free end is positioned
directly above the connector.
Note: Use caution to move the lever slowly to avoid
damaging the fiber.
4.5
CRITICAL STEP: Watch for the cable holder to
slide backward approximately 1 mm as the lever
comes down. Do not proceed to the next step until
seeing this.
Note: The cable holder slides backward, because the lever
moves the jig tip, which pushes the fiber backward.
4.6
Press down hard on the free end of the activation
lever to activate the fiber crimping mechanism
within the connector. After a click sound, the
lever will be stopped and cannot be pushed any
further.
Note: Never activate a connector without a fiber in it or
with a fiber only partially inserted. Doing so will
ruin the connector.
Watch for cable
holder to slide
backward
approximately
1 mm.
Push hard
Note: If you are not sure if the click was heard, and therefore not sure if the fiber is crimped, inspect the cap
surface. A raised surface indicates the fiber IS NOT crimped. A flush, even surface indicates the fiber IS
crimped.
Not crimped
Crimped