![background image](http://html1.mh-extra.com/html/3m/crimplok-6702-50-50-um-mm/crimplok-6702-50-50-um-mm_instructions-manual_442851013.webp)
78-0015-0557-3-B
13
5.1
Complete the installation process using the 3M™
Cr SC Nano Finishing Tool. Open the
lid on the finisher by first depressing the latch. For
proper performance, only one finishing disc may be
installed at a time. Use a new disc for each
connector. Discs are provided in the connector
package. Remove the adhesive-backed finishing
disc from the protective liner, and place it onto the
backup pad. Center the disc on the pad using the
through hole and pin as visual references. Press the
disc against the backup pad while taking care to
keep it clean. Keep pressing the disc down until
there are no air pockets under it. It is okay for your
fingers to touch the polishing surface while
pressing the disc down.
5.2
Wet the top surface of the finishing disc with 2
squirts of de-ionized or distilled water using the
spray bottle provided. Avoid using excessive
amounts of water. Close the lid fully and ensure the
latch is engaged.
Note: Wetting the disc surface is important because it
carries off glass particles that have been removed.
Failure to wet the disc results in poor connector
performance.
5.0 Nano-finishing and Cleaning
5.3
Insert the connector into the port on the 3M™ Cr Nano Finishing Tool lid making certain it is
fully engaged. Push until a click is heard.
Push down
further
Push down until
it clicks
5.4
Press the release button on the side of the finisher.
The button will stay depressed until the finishing
sequence is complete. It pops back up
automatically. Allow this to happen by keeping
clear of the button during the sequence.