3DCPI-02
START-UP GUIDE
Printing from computer
1. Click “Print” icon (as shown) at the top left corner of the window.
2. The window shows as below and the printer starts running. It may stay at one
position for a while to heat up. When the nozzle is at desired temperature (displayed at
the top right corner of the window), plastic will start to be extruded out of the nozzle.
3. If you want to pause or stop building, click the icons as shown below.
NOTE:
In the initial phase of 3D printing (when the status bar below toolbar is yellow), the
Pause and Stop icons are disable. You can close ReplicatorG to pause building.
While building, it may take seconds to pause after clicking Pause. Sometimes it may
take about 30 seconds which depends on your computer configuration. DON’T hit
Pause again when waiting.
4. When finishing building, you’ll see the icon below. Take the model out by hands or
shovel.
NOTE: Before powering off the printer, click the “Disconnect” icon (as shown below).