3DCPI-02
START-UP GUIDE
After about 30 seconds, the estimation is displayed at the bottom of the window (as
shown below). It may take 3 hours and 15 minutes to build our sample. Usually, it takes
longer than estimated.
4. Generating GCode(Slicing)
a. Click the “Generate GCode” button at the lower right corner of the window. Then the
following prompt pops up, if the model is adjusted but not saved. Click “Yes” to save
changes. Otherwise, click “No”. Suggest clicking “Yes” to generate GCode.
b. After clicking “Generate GCode”, the following window pops up. Red arrows point
to our tips.
c. When finishing setting up, click the “Generate GCode” button and you´ll see the
window showing progress as below.
Select 3DCPI-
02
Recommend checking it.
Rafts are automatically
generated under the
bottom of the models.
Fill Density: 0%, only a shell,
empty inside; 1%-99%,
hexagonal structure; 100%,
solid.
Test printing cubes to observe
differences. As the fill density
decreases, less material is used.
Set according to your
requirements.
Check these options.
If you´re following our
example, please select
“Outside” support, as our
sample model has no
material beneath to support
it on the right.
If the model has
overhanging features inside,
please select “Full” support.
Any value between 0.1 and
0.3. Suggest inputting 0.15.
The smaller value you input,
the better quality you get.
Suggest inputting 25.
The smaller, the better,
but it takes more time to
build.