3D
Aeroventures
N�v�r S�o� E�p�o�i�g� N�v�r S�o� Q�e�t�o�i�g� N�v�r S�o� P�a�i�g
- 2� -
Step-by-Step Build Guide (cont’d)
Step 4.3 Install the Elevons and Servos
4.3.1 Holding Elevon R1/R2 in place in the wing, route the 1mm O.D. carbon
fiber rod through the entry hole in Back Wing Tip R, through the elevon
and wing hinge holes, until the rod exits the other side of the elevon
and is fully inserted. You may use a 1mm steel rod to clear out any
debris in the hinge holes or drill out the hinge holes in the wing with a
1.2mm drill bit if needed.
4.3.2 Using the mounting screws that came with your servo, mount the servo
to part Servo Cover R.
Note: It is recommended to test and center the
servos and install the servo control horn prior to installation.
