3D
Aeroventures
N�v�r S�o� E�p�o�i�g� N�v�r S�o� Q�e�t�o�i�g� N�v�r S�o� P�a�i�g
- 2� -
Step-by-Step Build Guide (cont’d)
4.2.1 Glue parts Back Wing R2 - Back Wing R5
together using CA glue. Spray accelerator on
the joints to speed curing of the CA glue. The
built in alingment tabs will keep all parts well
aligned. You can then glue on parts Back Wing
Tip R and Middle Wing Tip R
4.2.1 Repeat steps 4.2.1 and 4.2.2 for the Back Left Wing, using parts Back
Wing L1 - Back Wing L5, Back Wing Tip L, and Middle Wing TIp L for the wing.
Use parts Elevon L1 and Elevon L2 for the elevon.
Step 4.2 Glue The Back Wing Parts Together
4.2.2 Prior to gluing parts Elevon R1 and Elevon R2 together, use the 1mm - 1.5mm
O.D. carbon fiber rod or steel rod to make sure it slides freely in the
hinge hole. Then glue the two elevon parts together using the carbon
fiber rod and 10mm length 3mm dowel pins to keep the two parts
aligned.
BE VERY CARFEUL NOT TO GLUE THE CARBON FIBER ROD
PERMANENTLY IN PLACE
