Vert Stab
Back Wing R1
Back Wing
L1
3D
Aeroventures
N�v�r S�o� E�p�o�i�g� N�v�r S�o� Q�e�t�o�i�g� N�v�r S�o� P�a�i�g
- 1� -
Step-by-Step Build Guide (cont’d)
Note: You can choose to route the 24” + 6” servo extensions through the vert
stab and fuselage at this point, before gluing on the
Vert Stab/ Back Wing R1/ Back Wing L1. This can make the routing
process easier. Otherwise, use a piece of string with a weight (such as a
lock nut) tied to one end, and your servo extension lead tied to the other
end. Use the weighted string to aid in routing the extension.
ALWAYS TEST YOUR EXTENSIONS AND SERVOS PRIOR TO INSTALLATION
2.3.5 Glue the Vert Stab/Back Wing R1/Back Wing L1 sub-assembly to your
Fuselage assembly using CA glue. The built in alingment tabs will keep
all parts well aligned.
2.3.3 Glue parts Back Wing R1 and Back Wing L1 together using CA glue. Use the
6mm carbon fiber tubes to ensure good alignment between the two parts,
being careful not to permanently glue the carbon fiber tubes to the printed
parts.
NOTE: Parts Back Wing R1 and Back Wing L1 each contain a sacrificial support
this can be pulled away with slight force.
2.3.4 Glue the Back WingR1/L1 sub-assembly to the top of the part Vert Stab
Back Wing R1 & L1
Removable Support
