3Com VCX V7000, Installation And Maintenance Manual

Page: 48 / 144

48 C
HAPTER
2: I
NSTALLATION
S
CRIPTS FOR A
S
INGLE
P
AIR OF
S
ERVERS
Sample UMS
Installation Script
(Secondary Server)
After the network installation script has been completed, the UMS
installation script starts.
UMS Installation Script — Secondary Server
Type of VCX 7300 Installation (S-Standalone/C-Client/V-Server)? [S]
Press the Enter or Return key to accept Standalone as the suggested
answer.
Number of voip ports? [144]
Press the Enter or Return key to accept the default number (144) of VOIP
ports that the system will support. Do
not enter a different value without
consulting 3Com.
IP address of the outbound proxy? [10.20.30.43]
Outbound Proxy is another name for the Call Processor. Enter the IP
address of the
primary VCX Call Processor.
Name of the SIP DDD? [10.20.30.43]
The SIP Default Dialing Domain software runs on the same server as the
VCX Call Processor. Press the Enter or Return key to accept the IP address
of the primary VCX Call Processor.
TCP/UDP Port on which the VCX 7300 will receive SIP messages [5060] 5060
Press the Enter or Return key to accept 5060 as the suggested answer.
The VCX Call Processor and UMS use the same port number but on
different IP addresses.
IP address of the secondary proxy? (hit Enter if none) [ ] 10.20.30.41
Enter the IP address of the secondary VCX Call Processor server
(10.20.30.43 in this sample configuration that contains a single pair of
servers).
Intelligent Mirroring configurations
Should Intelligent Mirroring be enabled (Y/N)? [N]: y
All supported UMS configurations require Intelligent Mirroring. Enter y.
Enter the Device Name of the Network Card to be used by UMS? : eth0
Enter the Device Name of the Second Network Card to be used by UMS, press ENTER if
only one? :
Press the Enter or Return key to indicate that UMS uses only the eth0
network card.
Name of the Remote Intelligent Mirrored system? [ ] vcx01
Enter the name of the active UMS server (vcx01 in this example).