3Com Switch 8807, Command Reference Manual

Page: 403 / 1099

RIP Configuration Commands 401
host-route Syntax
host-route
undo host-route
View
RIP view
Parameter
None
Description
Use the host-route command to control the RIP to accept the host route.
Use the undo host-route command to reject the host route.
By default, RIP accepts the host route.
In some special cases, RIP receives a great number of host routes in the same
network segment. These routes cannot help the path searching much but occupy
a lot of resources. In this case, the
undo host-route command can be used to
reject a host route.
Example
# Configure RIP to reject a host route.
[3Com-rip] undo host-route
import-route Syntax
import-route protocol [ cost value | route-policy route-policy-name ]*
undo import-route protocol
View
RIP view
Parameter
protocol : Specifies the source routing protocol to be imported by RIP. At present,
RIP can import the following routes: direct , bgp , ospf , ospf-ase , ospf-nssa , isis
and static .
value : Cost value of the route to be imported.
route-policy route-policy-name : Configures to import the route matching the
condition of the specified Route-policy only.
Description
Use the import-route command to import the routes of other protocols into RIP.
Use the undo import-route command to cancel the routes imported from other
protocols.