3Com Switch 8807, Command Reference Manual

Page: 341 / 1099

RADIUS Protocol Configuration Commands 339
primary authentication Syntax
primary authentication ip-address [ port-number ]
undo primary authentication
View
RADIUS scheme view
Parameter
ip-address : IP address, in dotted decimal format.
port-number : Specifies UDP port number. ranging from 1 to 65535.
Description
Use the primary authentication command to configure the IP address and port
number for the primary RADIUS authentication/authorization.
Use the undo primary authentication command to restore the default IP
address and port number of the primary RADIUS authentication/authorization.
By default, the primary authentication server of the RADIUS scheme created by the
system, whose name is "system", uses IP address of 127.0.0.1 and UDP port of
1645. The secondary authentication server uses IP address of 0.0.0.0 and UDP port
of 1812. The primary and secondary authentication server of a newly created
RADIUS scheme uses IP address of 0.0.0.0 and UDP port of 1812.
After creating a RADIUS scheme, you are supposed to set IP addresses and UDP
port numbers for the RADIUS servers, including primary/secondary
authentication/authorization servers and accounting servers. In real networking
environments, the above parameters shall be set according to the specific
requirements. However, at least you have to set one authentication/authorization
server and an accounting server. Besides, ensure that the RADIUS service port
settings on the switch is consistent with the port settings on the RADIUS server.
Related command: key , radius scheme , state .
Example
# Set the IP address of the primary authentication/authorization server of RADIUS
scheme, "3com", to 10.110.1.1 and the UDP port 1812 to provide RADIUS
authentication/authorization service.
[3Com-radius-3com] primary authentication auth 10.110.1.1 1812
radius client Syntax
radius client enable
undo radius client
View
System view