3Com OfficeConnect 3CP4144, Cli User'S Manual

Page: 99 / 144

CLI Commands B-19
■
Type - interface type: Ethernet or Token Ring
■
If Name - eth:1, DA:1 or loopback
list ip interface_block
Displays the IP addresses associated with each system interface. If the interface has
a point-to-point connection, then the neighbor field contains the address of the
remote system. This command lists:
■
Address - IP address of the interface
■
Neighbor - IP address of the remote system
■
Status - status of the connection; ENABLED or DISABLED
■
Interface - eth:1, DA:1 or loopback
list ip networks
Displays all the IP networks you previously defined using the add ip network
command. It also lists:
■
Name - network designation
■
Prot - always the IP protocol
■
Int - name of the interface this network runs on
■
State - state of the network; ENABLED or DISABLED
■
Type - STATIC or DYNAMIC network
■
Network Address - address of the IP network
list ip routes Displays all the statically defined IP routes that you previously defined using the
add ip route command . It lists:
■
Destination - IP address that the route resolves to
■
Prot - LOCAL or RIP
■
NextHop - address of the gateway used to reach this route
■
Metric - number of router hops away this route is from the system
■
If - interface that the route uses
list ipx networks Displays the IPX networks that you previously defined using the add ipx network
command. It lists:
■
Name - designation you assigned this network
■
Prot - protocol; always IPX
■
Int - interface each IPX network runs on
■
State - ENABLED or DISABLED
■
Type - STATIC or DYNAMIC
■
Network Address - network address of this IPX network
list ipx routes
Displays the IPX routes that you previously defined using the add ipx route
command, plus the defined IPX nodes. It lists:
■
Network Addr - network address of this route
■
Prot - protocol used to find this route: LOCAL, RIP, STATIC, NLSP, OTHER