3Com OfficeConnect 3CP4144, Cli User'S Manual

Page: 93 / 144

CLI Commands B-13
disable command
password
Disables the console password feature.
disable icmp
Disables the Internet Control Message Protocol .
disable interface
<interface_name>
Disables the specified interface. A disabled interface remains in the interface
table, but will not transmit or receive any data. Use
list interfaces to see the
currently defined interfaces, and their status.
disable ip forwarding
Causes the system to stop forwarding any packets over IP networks.
disable ip network
<network_name>
Disables the specified IP network. Make sure there is no activity on this network
before disabling it.
disable ip rip Disables the RIP routing algorithm on all IP networks. You can use show ip routing
to see the current status of IP routing. This saves system space by preventing a
large RIP database, which is useful for networks connecting over the WAN
interface.
disable ip routing
Disables all routing protocols on all IP networks. Currently, the only routing
protocol is RIP, which means that
disable ip rip performs the same function. Use
show ip routing to see the current status of IP routing.
disable ip
static_remote_routes
Disables all statically defined remote routes on all IP networks, that you previously
defined using
add ip route . You can list the current IP routes using list ip routes .
disable ipx network
<network_name>
Disables the specified IPX network. Use list ipx networks to see which IPX
networks are defined, and their current status.
disable lan access When the access list is enabled, this command disables access to Hosts on the
local LAN interface. When disabled, all frames received on the LAN interface are
subject to the access list check. If the corresponding LAN subnet is not in the
access list, the frame is silently discarded.
disable link_traps
interface
<interface_name>
Prevents SNMP from sending linkup and linkdown traps for the specified interface.
You can see if the interface is currently enabled for traps by using the
show
interface settings command.
disable network service
<service_name>
Disables a network service, such as TELNET or TFTP. If close_active_connection’ was
specified as TRUE in the add network_service command, then all active
connections will be closed when the server is disabled.
disable security_option
snmp user_access
Turns off SNMP access to the CLI. This prevents remote users from using SNMP
and possibly damage the configuration. You can use
enable security_option snmp
user_access to re-enable full SNMP access. NOTE: This function is not supported in
the current release.