3Com NETBuilder SI, Using Manual

Page: 82 / 212

82 C
HAPTER
7: A
DVANCED
C
ONFIGURATION OF
P
ORTS AND
P
ATHS
Scenario 2: Using Both B Channels Together
If you need to connect to one location at 128 Kbps, use both B channels
together.
The destination must be running Multilink PPP, either on the NETBuilder
bridge/router with a built-in ISDN port or on the TA.
Scenario 3: Connecting to Multiple Destinations
If you need to connect to multiple destinations using one or both B
channels, use a dial pool that contains all ISDN paths. The following
scenarios show how a SuperStack II bridge/router using a dial pool can
connect to three different locations.
Start here
Done
B1 & B2: 128 K
Create the dial number list for port 3. If you have one phone number
for your destination, enter the number twice with a letter after the
second entry. If you have two numbers, enter each phone number:
ADD !3 -PORT DialNoList "1-408-555-1000" Baud = 64 Type = Bri
ADD !3 -PORT DialNoList "1-408-555-1000a" Baud = 64 Type = Bri
Add path 3.2 to port 3:
ADD !3 -PORT PAths 3.2
Set the normal bandwidth for port 3:
SETDefault !3 -PORT NORMalBandwidth = 128
Enable Multilink PPP on port 3:
SETDefault !3 -PPP MlpCONTrol = Enabled, NoFragment
1-408-555-1000
!3
Both B channels connect
to one destination.
!3.1 & !3.2 (paths)
ADD !<port> -PORT PAths <connectorID.channelID> [,...] Syntax:
SETDefault !<port> -PPP MlpCONTrol = ([Enabled | Disabled],
[Fragment | NoFragment])
SETDefault !<port> -PORT NORMalBandwidth = <kbps> (>=0)
ADD !<port> -PORT DialNoList "<phone no>"
[Baud = <rate> (1.2–16000)] [Type = Modem | Bri | Sw56]
[Pos = <number>]
Syntax:
Syntax:
Syntax: