3Com Fast EtherLink 3C515-TX, User Manual

Page: 57 / 80

Changing the Settings 6-3
2 Boot the PC under DOS.
The Configuration and Diagnostic Program will not run
if memory managers or other device drivers have been
loaded. To allow the program to run, do one of
the following:
■
Boot the PC from a DOS diskette that does not
contain device drivers.
■
If your computer is running an operating system other
than DOS, exit to the DOS prompt. For instructions,
see the operating system documentation.
3 Insert the EtherDisk diskette in drive A and type the
following at the DOS prompt:
a:\install [Enter]
4 When the Select an Adapter screen shown in
Figure 6-1 appears, select the NIC and press [Enter].
Figure 6-1 Select an Adapter Screen
If one NIC is installed, the Configure Adapter option
appears selected on the Install pull-down menu.
Press [Enter].
A screen similar to the one shown in Figure 6-2 appears,
showing the parameters for the selected NIC.
EtherDisk-3C515 Fast EtherLink ISA 10/100 Base TX Adapter v1.0
Initial Adapter Selection
Select Quit
Select the adapter to be configured and/or tested.
[ENTER]=<Select>
[Alt]+<Highlighted Key>=Execute Function [
↑↓
]=Scroll
[TAB]=Next Field [SHIFT+TAB]=Previous Field [F1]=Help [ESC]=<Quit>
Installed Adapters
3Com 3C515-TX: Ethernet Address = 0060C0BC00D1
3Com 3C509B-TP: Ethernet Address = 00600C34C320
Install Quit View Select F1=Help Test