54
C
HAPTER
4: I
NSTALLING
AND
C
ONFIGURING
IN
N
ET
W
ARE
4 Press F3 to set the frame types.
Use the arrow keys to select frame types. Select as many of
the supported frame types as required. Adding frame types
after exiting the installation program is best done by
editing the AUTOEXEC.NCF file. The default is 802.2 only.
Ethernet_802.3, Ethernet_II, and Ethernet_SNAP frame
types are also supported.
5 To use the default MAC address of the NIC, leave the
Node Address field blank.
The default MAC address is recommended for most
installations.
6 Select Log Message Level and press Enter.
7 Select which messages to log from the pop-up box
and press Enter.
All messages are printed to the system console screen and
to the SYS:\SYSTEM\SYS$LOG.ERR file. All messages are
logged by default.
8 Set receive checksumming.
This parameter applies only to NetWare 5.0. It must be
disabled in NetWare 4.2.
9 Set transmit checksumming.
This parameter applies only to NetWare 5.0. It must be
disabled in NetWare 4.2.
10 To configure the SHD:
From the SHD Configuration field, select
Configure SHD
.
The following SHD parameter fields appear:
Check Level
Transmit/Receive Error Threshold
Sampling Window Size
The default values of the SHD parameters are optimal for
most networks. See
Table 3
for explanations of the
parameters.
