1-19
To do…
Use the command…
Remarks
Configure line rate
line-rate
{
inbound
|
outbound
}
target-rate
[
burst-bucket
burst-bucket-size
]
Required
Specify a committed information
rate (CIR) for the
target-rate
argument, and specify a
committed bust size (CBS) for the
burst-bucket-size
argument.
By default, line rate is disabled.
Configuration example
z
Configure line rate for outbound packets on Ethernet 1/0/1.
z
The rate limit is 1,024 Kbps
Configuration procedure:
<Sysname> system-view
[Sysname] interface Ethernet1/0/1
[Sysname-Ethernet1/0/1] line-rate outbound 1024
Configuring VLAN Mapping
Refer to section
VLAN Mapping
for information about VLAN mapping.
Configuration prerequisites
z
The ACL rules used for traffic classification have been defined. Refer to the ACL module
of this
manual for information about defining ACL rules.
z
The ports on which the configuration is to be performed have been determined.
z
The VLAN ID to be set for the packets has been determined.
Configuration procedure
Follow these steps to configure VLAN mapping:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter Ethernet port view
interface
interface-type
interface-number
—
Configure VLAN mapping
traffic-remark-vlanid inbound
acl-rule
remark-vlan remark-vlanid
Required
By default, VLAN mapping is
not configured.
Configuring Queue Scheduling
Refer to section
Queue Scheduling
for information about queue scheduling.
Configuration prerequisites
The algorithm for queue scheduling to be used and the related parameters have been determined.
