1-9
To do…
Use the command…
Remarks
Enter system view
system-view
—
Set the XRN fabric
authentication mode for the
switch
xrn-fabric
authentication-mode
{
simple
password
|
md5 key
}
Optional
By default, no authentication
mode is set on a switch.
When an XRN fabric operates normally, you can regard the whole fabric as a single device and perform
configuration on it. Multiple switches constitute an XRN fabric. Therefore, data transmission and
simultaneous program execution among the switches may cause the XRN fabric in a busy situation.
When you configure the XRN fabric, you may receive a prompt “Fabric system is busy, please try
later…” which indicates the fabric system does not perform your configuration properly. In this case, you
need to verify your previous configuration or perform your configuration again.
Displaying and Maintaining XRN Fabric
To do…
Use the command…
Remarks
Display the information about
an XRN fabric
display xrn-fabric
[
port
]
Display the topology
information of an XRN fabric
display ftm
{
information
|
topology-database
}
Available in any view
Clear the FTM statistics
reset ftm statistics
Available in user view
XRN Fabric Configuration Example
Network Requirements
Configure unit ID, unit name, XRN fabric name, and authentication mode for four switches to enable
them to form an XRN fabric as shown in
Figure 1-3
.
The configuration details are as follows:
z
Unit IDs: 1, 2, 3, 4
z
Unit names: unit 1, unit 2, unit 3, unit 4
z
Fabric name: hello
z
Authentication mode: simple password
z
Password: welcome
