1-47
MSTP Configuration Example
Network requirements
Implement MSTP in the network shown in
Figure 1-10
to enable packets of different VLANs to be
forwarded along different MSTIs. The detailed configurations are as follows:
z
All switches in the network belong to the same MST region.
z
Packets of VLAN 10, VLAN 30, VLAN 40, and VLAN 20 are forwarded along MSTI 1, MSTI 3, MSTI
4, and MSTI 0 respectively.
In this network, Switch A and Switch B operate on the convergence layer; Switch C and Switch D
operate on the access layer. VLAN 10 and VLAN 30 are limited in the convergence layer and VLAN 40
is limited in the access layer. Switch A and Switch B are configured as the root bridges of MSTI 1 and
MSTI 3 respectively. Switch C is configured as the root bridge of MSTI 4.
Network diagram
Figure 1-10
Network diagram for MSTP configuration
The word “permit” shown in
Figure 1-10
means the corresponding link permits packets of specific
VLANs.
Configuration procedure
1) Configure Switch A
# Enter MST region view.
<Sysname> system-view
[Sysname] stp region-configuration
# Configure the region name, VLAN-to-instance mapping table, and revision level for the MST region.
[Sysname-mst-region] region-name example
[Sysname-mst-region] instance 1 vlan 10
[Sysname-mst-region] instance 3 vlan 30
[Sysname-mst-region] instance 4 vlan 40
[Sysname-mst-region] revision-level 0
# Activate the settings of the MST region manually.
[Sysname-mst-region] active region-configuration
