2N TELEKOMUNIKACE a.s., www.2n.cz
31/85
1.
2.
3.
4.
5.
6.
7.
Warning
Be sure keep strictly the hole dimensions while mounting the device into
classic bricks without the flush mounting box as shown in the picture with
dimensions.
Flush Mounting – Classic Bricks
What You Need:
The brick flush mounting box, Part No. 9151001
The metal frame, Part No. 9152000
Hole: (132 x 223 x 83) mm
If you use the brick flush mounting box, follow the instructions below:
Make a hole using the template.
Suppose that all the required cables have been carried into the hole.
Put the intercom inside and place the set onto the hole to make sure that the
hole is deep enough and the uneven edge is perfectly covered with the frame.
If the hole is perfect, wall in the flush mounting box.
Remove the front panel from the intercom.
Select the holes for cable supply. Insert the blanks into the other holes. Apply the
cable bushings or a suitable sealant to prevent penetration of insects or water.
You can also insert the small bushing in the intercom bottom hole.
Put the frame on the intercom.
Summary of Contents for 01353-001
