Prestige 310 Broadband Sharing Gateway
Remote Node Setup
4-7
Figure 4-4 Remote Node Network Layer Options
The next table gives you instructions about configuring remote node network layer options.
Table 4-4 Remote Node Network Layer Options Menu Fields
FIELD
DESCRIPTION
EXAMPLE
IP Address
Assignment
If your ISP did not assign you an explicit IP address, select
Dynamic
; otherwise select
Static
and enter the IP address & subnet
mask in the following fields.
Dynamic
IP Address
If you have a static IP address, enter the IP address assigned to you
by your ISP.
IP Subnet
Mask
If you have a static IP assignment, enter the subnet mask assigned
to you.
Gateway IP
Addr
If you have a static IP assignment, enter the gateway IP address
assigned to you.
Network
Address
Translation
Use the [SPACE BAR] to select either
Full Feature
,
None
or
SUA
Only
. See the
NAT
chapter
for a full discussion of this feature.
SUA Only
Metric
This field is valid only for PPTP/PPPoE encapsulation. The metric
represents the “cost” of transmission for routing purposes. IP routing
uses hop count as the measurement of cost, with a minimum of 1 for
directly connected networks. Enter a number that approximates the
cost for this link. The number need not be precise, but it must be
between 1 and 15. In practice, 2 or 3 is usually a good number.
3
Private
This field is valid only for PPTP/PPPoE encapsulation. This
parameter determines if the Prestige will include the route to this
Yes
Menu 11.3 - Remote Node Network Layer Options
IP Address Assignment= Dynamic
IP Address= N/A
IP Subnet Mask= N/A
Gateway IP Addr= N/A
Network Address Translation= SUA only
Metric= N/A
Private= N/A
RIP Direction= None
Version= N/A
Multicast= None
Enter here to CONFIRM or ESC to CANCEL:
Press Space Bar to Toggle.
