Prestige 310 Broadband Sharing Gateway
10-6
Firmware and Configuration Maintenance
Table 10-3 General Commands for Third Party TFTP Clients
COMMAND
DESCRIPTION
Host
Enter the IP address of the Prestige. 192.168.1.1 is the Prestige’s
default IP address when shipped.
Send/Fetch
Use “Send” to upload the file to the Prestige and “Fetch” to back up
the file on your computer.
Local File
Enter the path and name of the firmware file (*.bin extension) or
configuration file (*.rom extension) on your computer.
Remote File
This is the filename on the Prestige. The filename for the firmware is
“ras” and for the configuration file, is “rom-0”.
Binary
Transfer the file in binary mode.
Abort
Stop transfer of the file.
Refer to the
TFTP and FTP over WAN
section to read about configurations that disallow TFTP and FTP to
work over WAN.
10.2.5 Backup Via Console Port
Backup configuration via console port by following the HyperTerminal procedure shown next. Procedures
using other serial communications programs should be similar.
Step 1.
Display menu 24.5 and enter “y” at the following screen.
Figure 10-3 System Maintenance — Backup Configuration
Step 2.
The following screen indicates that the Xmodem download has started.
Figure 10-4 System Maintenance — Starting Xmodem Download Screen
Step 3.
Run the HyperTerminal program by clicking
Transfer
, then
Receive File
as shown in the
following screen.
Ready to backup Configuration via Xmodem.
Do you want to continue (y/n):
You can enter ctrl-x to terminate operation any time.
Starting XMODEM download...
