P-660R-Tx v2 Series Support Notes
wan atm vchunt add <remoteNodeIndex> <vpi> <vci> <service
bit(hex)>
wan atm vchunt save
Note: <remote node> : input the remote node index 1-8
<vpi> : vpi value
<vci> : vci value
<service>: it’s a hex value, bit0:PPPoE/VC (1), bit1:PPPoE/LLC (2) ,
bit2:PPPoA/VC (4), bit3:PPPoA/LLC (8), bit4:Enet/VC (16), bit5 :Enet/LLC (32)
For examples:
If you need service PPPoE/LLC and Enet/LLC then the service bits
will be 2+32 = 34 (decimal) = 22 (hex), you must input 22
If you want to enable all service for VC hunting, the service bits will be
1+2+4+8+16+32=63(decimal)= 3f (hex), you must input 3f
Need to perform save after this by command ‘
wan atm vchunt save
’
(3) Delete items from the auto-haunting preconfigured table via command:
wan atm vchunt remove <remote node> <vpi> <vci>
•
Using Zero configuration.
(1) After configure the auto-haunting preconfigured table. You just need a PC
connected to the device LAN Ethernet port with the DSL sync up.
63
All contents copyright © 2006 ZyXEL Communications Corporation.