P-660R-Tx v2 Series Support Notes
11. Using IP Multicast
•
What is IP Multicast ?
Traditionally, IP packets are transmitted in two ways - unicast or broadcast.
Multicast is a third way to deliver IP packets to a group of hosts. Host groups
are identified by class D IP addresses, i.e., those with "1110" as their
higher-order bits. In dotted decimal notation, host group addresses range from
224.0.0.0 to 239.255.255.255. Among them, 224.0.0.1 is assigned to the
permanent IP hosts group, and 224.0.0.2 is assigned to the multicast routers
group.
IGMP (Internet Group Management Protocol) is the protocol used to support
multicast groups. The latest version is version 2 (see RFC2236). IP hosts use
IGMP to report their multicast group membership to any immediate-neighbor
multicast routers so the multicast routers can decide if a multicast packet
needs to be forwarded. At start up, the P-660R-Tx v2 queries all directly
connected networks to gather group membership.
After that, the P-660R-Tx v2 updates the information by periodic queries. The
P-660R-Tx v2 implementation of IGMP is also compatible with version 1. The
multicast setting can be turned on or off on Ethernet and remote nodes.
•
IP Multicast Setup
(1) Enable IGMP in P-660R-Tx v2's LAN in Web Configurator, Advanced
Setup,
-> LAN -> LAN Setup.
(2) Enable IGMP in P-660R-Tx v2's remote node via command:
wan node index <node#>
Usage: node#= 1~8
wan node multicast < none | igmpv1 | igmpv2 >
wan node save
Key Settings:
Multicast
IGMP-v1 for IGMP version 1, IGMP-v2 for IGMP version 2.
12. Using Zero-Configuration
•
Zero-Configuration
and VC auto-hunting
61
All contents copyright © 2006 ZyXEL Communications Corporation.
