ZyXEL Communications LTE5366 Series, Руководство пользователя

Страница: 144 / 228

Chapter 20 Remote Management
LTE5366 Series User’s Guide
144
20.5 Remote Management
Use this screen to configure through which IP address the LTE5366 can be accessed. You can also
specify the port numbers the IP addresses must use to connect to the LTE5366. Click
Configuration >
Management > Remote MGMT > Remote Management to open the following screen.
Note: The firewall will be disabled when remote management is enabled. To activate the
firewall, you’ll need to create a new firewall rule to allow the remote management
traffic to come in from the WAN side.
Figure 91 Configuration > Management > Remote Management > Remote Management
The following table describes the labels in this screen.
Cancel Click Cancel to return the screen to its last-saved settings.
Apply Click Apply to save your changes back to the LTE5366.
Table 62 Configuration > Management > Remote Management > WWW
LABEL DESCRIPTION
Table 63 Configuration > Management > Remote Management > Remote Management
LABEL DESCRIPTION
Remote Management Settings
Remote Management Select the Enable check box to allow access to the LTE Device from the IP address
and activate the settings you’ve made in the WWW screen.
IP address This is the IP address of a computer that may use to access the LTE5366.
Netmask This is the subnet mask identifying a computer that may access remotely to the
LTE5366.
Port This is the port number that the computer must use to access the LTE5366. If the HTTP
Port number was changed to 8080 in the
Configuration > Management > Remote
Management > WWW screen, then this computer should use the same number. For
example http://1.1.1.1:8080 where 1.1.1.1 is the IP address of the LTE5366.
SSH Management
Remote Management Select the Enable to allow the computer with the IP address that matches the IP
address to access the LTE5366 CLI using SSH service.