ZyXEL Communications EMG6726-B10A, Руководство пользователя

Страница: 132 / 323

Chapter 9 Routing
EMG6726/8726-B10A User’s Guide
132
9.5 RIP
Routing Information Protocol (RIP, RFC 1058 and RFC 1389) allows a device to exchange routing
information with other routers.
9.5.1 The RIP Screen
Click Network Setting > Routing > RIP to open the RIP screen.
Figure 80 RIP
The following table describes the labels in this screen.
Source Interface Type the name of the interface from which the matched traffic is sent.
WAN Interface Select a WAN interface through which the traffic is sent. You must have the WAN interface(s)
already configured in the
Broadband screens.
OK Click OK to save your changes.
Cancel Click Cancel to exit this screen without saving.
Table 37 Policy Route: Add/Edit (Sheet 2 of 2)
LABEL DESCRIPTION
Table 38 RIP
LABEL DESCRIPTION
# This is the index of the interface in which the RIP setting is used.
Interface This is the name of the interface in which the RIP setting is used.
Version The RIP version controls the format and the broadcasting method of the RIP packets that the
EMG sends (it recognizes both formats when receiving). RIP version
1 is universally supported but
RIP version 2 carries more information. RIP version 1 is probably adequate for most networks,
unless you have an unusual network topology.
Operation Select Passive to have the EMG update the routing table based on the RIP packets received
from neighbors but not advertise its route information to other routers in this interface.
Select Active to have the EMG advertise its route information and also listen for routing updates
from neighboring routers.
Enable Select the check box to activate the settings.