ZXR10 2900 Series User Manual
Note:
There is big difference between ONU and switch for the function
took by ZXR10 2920 and ZXR10 2928. Therefore ZXR10 2920 and
ZXR10 2928 can’t act as ONU and traditional switch at the same
time.
Basic Configuration of EPON
To configure EPON, perform the following steps.
1. To restart PON subboard, use the following command.
Command
Function
zte(cfg)#
set epon reset
This restarts PON
subboard.
2. To enable or disable the port on PON subboard, use the follow-
ing command.
Command
Function
zte(cfg)#
set epon port
{
enable
|
disable
}
This enables or
disables the port
on PON subboard.
3. To configure the schedule mode of PON subboard, use the fol-
lowing command.
Command
Function
zte(cfg)#
set epon schedule
{
SP
|
WRR
<
1-8
>}
This configures the
schedule mode of PON
subboard.
4. To show link status of PON subboard, use the following com-
mand.
Command
Function
zte(cfg)#
show epon
This shows the status
of PON subboard.
5. To show PON subboard firmware information and EPON system
configuration information, use the following command.
140
Confidential and Proprietary Information of ZTE CORPORATION
