Zte ZXR10 2900 Series, Руководство пользователя

Страница: 102 / 262

ZXR10 2900 Series User Manual
Basic Configuration of SQinQ
To configure SQinQ, perform the following steps.
Command Function
zte(cfg)#
set sqinq-session < 1-256 >
customer-vlan < vlanlist > uplink-vlan
< 1-4094 >
This configures SQinQ
session.
zte(cfg)#
set policy policing in
sqinq-session < 1-256 > policer < 0-255 >
This configures traffic
rate limitation.
zte(cfg)#
clear policy policing in
sqinq-session < 1-256 >
This clears traffic rate
limitation.
zte(cfg)#
set policy statistics in
sqinq-session < 1-256 > counter < 0-31 >
This configures traffic
statistics.
zte(cfg)#
clear policy statistics in
sqinq-session < 1-256 >
This clears traffic
statistics.
zte(cfg)#
set policy mirror in
sqinq-session < 1-256 > analyze-port
This sets traffic mirror.
zte(cfg)#
clear policy mirror in
sqinq-session < 1-256 >
This clears traffic mirror.
zte(cfg)#
set port < portlist > sqinq-session
< sessionlist >{ enable | disable }
This applies SQinQ
session on port.
zte(cfg)#
clear sqinq-session
< sessionlist >
This clears the
configuration of SQinQ
session.
zte(cfg)#
show sqinq-session
[< sessionlist >]
This shows SQinQ
session.
Note:
When configuring SQinQ, policy configuration of SQinQ refers to
the related description about QoS.
SQinQ Configuration Example
As shown in Figure 47 , there are two switches of ZXR10-2952
(Switch A and Switch B) in Service Provider Network. Port 24 of
Switch A is connected to port 24 of Switch B. Vlan1-200 is in port
1–6 of Switch A which communicate with port 1–3 of Switch B in
which Uplink vlanid assigned as 100. Vlan201-4094 is in port 1–6
of Switch A which communicates with port 4–6 of Switch B in which
Uplink vlanid assigned as 200. CustomerPort of Switch A is untag
port only for Vlan1.
90 Confidential and Proprietary Information of ZTE CORPORATION