Zorlu EVC05 Series, Руководство пользователя

Страница: 25 / 51

English - 24 © 2021 ZES - All rights reserved IB v3.0.0 2021
9- Insert the prepared connector/cable
assembly into the RJ45 slot in your crimping
tool. Firmly squeeze the crimper’s handles
together until you can’t go any further. Relea-
se the handles and repeat this step to ensure
a proper crimp.
10- If your crimper doesn’t automatically trim
the wire ends upon termination, carefully cut
wire ends to make them as flush with the
connector’s surface as possible. The closer
the wire ends are trimmed, the better your
final plug-in connection will be.
11- Termination is complete.
12- Insert the Ethernet cable to the Ethernet bridge board in the left top side of the station as
shown in the figures below.
Table.1
3.8 - ETHERNET DAISY CHAIN
Daisy-Chain is a wiring method of the devices in a network. It gives an opportunity to add/remove
devices to/from network very easily. In order to make Daisy-Chain connection, an Ethernet hub
board is used as shown in figure, in the left-up side of the charging station. Basically it distributes
all the Ethernet connection among the devices. Ethernet line cable coming from a device, a router
or a hub needs to be connected to other device Daisy-Chain input port as shown in Figure. Internal
Ethernet connection (Between HMI system of the charging station and Ethernet Hub Board) is
made in production of the charging station. So all is needed to make the connections of Daisy-