53
ZOOM B9.1ut
Other Functions
HINT
• The available range setting depends on the
parameter.
• It is also possible to set "min" to a higher
value than "MAX". In that case, the control
change direction will be reversed.
When the control target and
5.
parameter range have been set,
turn the [TYPE] knob clockwise to
bring up the following display.
This display lets you select the control waveform
and cycle.
(994$9H[L
>H]L$<WZH^
[TYPE] knob
T he A R R M f u nct ion ha s a t ot a l of f ive
parameters. To set parameters 4 and 5, turn
the [TYPE] knob to bring up the above display
and then use parameter knobs 1 and 2 to make
the setting. To return to the setting condition
for parameters 1 – 3, turn the [TYPE] knob
counterclockwise to return to the previous
display. If the ARRM control target is set to
"Not Assign", this display does not appear.
Turn parameter knob 1 to select
6.
the control waveform type.
The display changes as follows.
(994$9H[L
>H]L$;YPHUNSL
Control waveform type
Parameter knob 1
Available waveforms are shown below.
Rising sawtooth
(Up Saw)
Rising fin
(Up Curve)
Falling sawtooth
(Down Saw)
Falling fin
(Down Curve)
2
1
3
4
Triangle
(Triangle)
Square triangle
(Square Tri)
Sine wave
(Sine)
Square wave
(Square)
6
5
7
8
Turn parameter knob 2 to select
7.
the control waveform cycle.
The display changes as follows.
(994$9H[L
:`UJ$_
Parameter knob 2
The control waveform cycle uses the patch
specific tempo (
→
p. 38) as reference and is
displayed as eighth note, quarter note, or quarter
note x numeral (see table on page 39).
The numeral after x (2 – 20) indicates the
duration of a cycle in multiple quarter notes.
When "2" is selected, the control waveform
changes in a cycle interval that corresponds to
half a note of the patch specific tempo. When
"4" is selected, the cycle is 4 beats (1 measure of
a 4/4 time signature).
HINT
When the "ARRM BPM" parameter is assigned
to the expression pedal, the reference tempo for
the ARRM function (0 – 250) can be controlled
with the pedal. For information on how to
assign control targets to the expression pedal,
see page 31. The expression pedal movement
will not change the patch speci
fi
c tempo.
When the ARRM setting is
8.
complete, press the [EXIT] key.
The unit returns to manual mode or play mode.
Store the patch as necessary.
NOTE
Any changes in ARRM settings will be lost when
you select a new patch. Be sure to store the
patch if you want to keep the changes (
→
p. 27).
0804B9E.indb 53
0804B9E.indb 53
08.4.25 10:58:53 AM
08.4.25 10:58:53 AM
