PAGE 17
A C C E S S
C O D E
O N
O F F
U P
D O W N
E N T E R
1
AC C E S S
C O D E
O N
O F F
U P
D O W N
E N T E R
1
DIAGRAM 18
CHANGING THE LEFT DIGIT
DIAGRAM 19
ENTERING THE FIRST 2 DIGITS
Changing the
Access Code
The preset code 1919 should be
changed to a number that you can
remember easily. Any number between
0001 and 9999 is allowed.
To change the ACCESS CODE, take
the following steps:
1. Turn the pitching machine OFF.
2. Simultaneously press and hold the
ON and the ENTER buttons until
the unit beeps.
3. Immediately after the beep sounds,
press and hold both
▲▼
buttons for
about 6 seconds while the display
runs through a short diagnostic
test. Hold the
▲▼
buttons until the
machine beeps twice.
NOTE:
If you do not hear two
beeps, you will have to start over
by turning the machine OFF.
4. A prompt for the first 2 digits of
your new ACCESS CODE appears
on the display. Use the
▲▼
buttons
to change the numbers. Entry of
the new code must begin within a
few seconds or the machine will
shut down and you will need to
begin again.
5. Press the
▲
key to change the left
digit. See Diagram 18.
6. Use the
▼
key to change the
right digit.
7. When the two digits of the code are
displayed, press ENTER.
8. The display prompts you to enter
ACCESS CODE 2, the second set of
2 digits. Follow steps 5–7 above.
The machine beeps twice which
confirms the entry of your new ACCESS
CODE. The code appears briefly on
the display and then the display
advances to PITCH mode.
9. Write down your new ACCESS CODE.
8
Содержание ZS 720
Страница 1: ......
