Zontes ZT310-X, Руководство по обслуживанию

Страница: 94 / 119

10、TANK LINER COMPONENT 93
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
1 1250205-043093 GB70.1 M8×55 (environmental color) 2
3 1244100-020000 ZT250-S fuel tank pressure 2
4 1244100-053000 ZT250-S second generation fuel tank gasket 2
5 1274100-080000 ZT250-R cushion fixing block 1
6 1244200-084000 ZT310-X1 fuel tank cover limit glue 2
7 1224200-066000 ZT310PKE external antenna mount 1
1050954-006000 ZT250-R EFI High Pressure Tubing Sub-assembly Delphi EFI
1050954-035000 ZT310-R EFI High Pressure Tubing Sub-assembly Bosch EFI
PROCEDURE:
●
Tank liner component
Remove the bolt
⑴
with a hexagonal tool; remove the gasket
⑵
and press the rubber
⑶
.
Lift the tail of the tank inner component and remove the rubber
⑷
and seat cushion
⑸
.
Pull the main harness limit card
①
out and pull the plug down.
After removing the antenna fixing block
⑹
from the inner liner component, clean the remaining glue.
Locate the limit retaining ring
②
on the high-pressure tubing sub-assembly
⑻
and pull it out while pressing
hard.
Continue to raise the tank liner assembly, clamp the tube clamp on the snorkel with pliers in the direction of the
arrow, and remove the vent tube.
Swing the tank liner assembly slightly left and right while pulling it back obliquely upwards.
Remove 2 pieces of limit glue
⑹
and 1 piece of antenna holder
⑺
from the tank liner, both of which are glued
to the tank liner with double-sided tape.
CAUTION:
●
The seat cushion, side cover, fuel tank cover, etc. must be removed in advance.
●
When removing the high-pressure oil pipe, be sure to wait until the engine and muffler are completely cooled
before operating to prevent accidental ignition of the fuel and cause fire.
●
Fireworks, answering or dialing should be strictly prohibited near the car-breaking site to prevent accidents.
●
A small amount of fuel leaks when the high-pressure tubing sub-assembly is pulled out, and the fuel should be
prevented from dripping to the outside of the engine or the muffler.
●
It is recommended to use the oil pump to pump out the fuel or consume the fuel before disassembling the tank
assembly.
Fig. 5 Tank liner component
Tank liner component
（
Big fuel tank
）
2 1251900-028093
ZT250-R fuel tank flat pad φ9×φ37.5×2
(environmental color)
2
1 8