Zontes ZT310-X, Руководство по обслуживанию

Страница: 59 / 119

8、FRONT FORK COMPONENT 58
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
1 1224200-052000 ZT310-X windshield 1
【
1
】
2 1251100-102000 Non-standard bolt M6×16 (304 stainless steel) 6
3 1224200-050000 Left pressing block on ZT310-X windshield 1
4 1244200-028000 ZT310-X windshield on the left press block rubber 2 after-sales
5 1224200-051000 Right pressing block on ZT310-X windshield 1
6 1244200-029000 Right pressure block rubber on ZT310-X windshield 2 after-sales
7 1264100-006000 ZT250-S pedal circlip 4
8 1274200-030000 Windshield lower pressing block rotating shaft 4
9 1274200-046000 ZT310-X windshield lower left block 1
10 1274200-047000 ZT310-X windshield right right pressure block 1
11 1224100-010000 ZT250-S expansion nail 2
12 1244100-052000 Cuff bushing cushioning rubber (φ8.5×φ14×1) 2
13 1274100-057095 Flanging bushing φ6.2×φ8.4×3.5+φ14×1.5 2
14 1224200-049000 ZT310-X windshield liner 1
PROCEDURE:
●
Windshield assembly
Hold the windshield
⑴
, remove the 4 bolts
⑵
, and remove the upper left clamp
⑶
and the upper right clamp
⑸
. Remove
the windshield assembly.
The upper left pressing block rubber
⑷
and the upper right pressing block rubber
⑹
on the front side of the windshield are
heated and softened by a heat gun, and then torn off, and the residual glue is cleaned.
Remove the clamp rubber on the back of the windshield as described above.
●
Windshield press block assembly
Hold the lower left clamp
⑼
and use the tool to push the circlip
⑺
out, then remove the rotary shaft
⑻
. Remove the lower
left clamp
⑼
.
Remove the right clamp
⑽
as described above.
●
Windshield liner assembly
Use a small Phillips screwdriver to push down the center of the expansion pin and remove the 2 expansion pins
⑾
.
Hold the windshield liner
⒁
, remove the bolt
⑵
, and remove the bushing
⒀
and cushion rubber
⑿
. Remove the windshield
liner.
CAUTION
：
●
When removing the rubber block, move the hot air gun back and forth. It is forbidden to blow the windshield when the
high temperature is right or the distance is too close or for a long time.
●
The windshield should be protected during the disassembly process to prevent scratches.
●
The circlip is small, keep it in good condition during the disassembly process, and prevent it from falling into the vehicle
interior.
●
The windshield lifting instructions are detailed in the driver's manual.
●【
1
】
The windshield already contains left press block rubber
⑷
and right press block rubber
⑹
.
Fig.10 FRONT FORK
COMPONENT
Windshield assembly(Electronic Instrument)