Zontes ZT310-X, Руководство по обслуживанию

Страница: 103 / 119

12、REAR COVER COMPONENT 102
CHK
ADJ
NO. PART NO. PART NAME QTY REMARKS
1 1251100-102000 Non-standard bolt M6×16 (304 stainless steel) 2
2 1274100-007000 ZT250-S flanged bushing 1
3 1184200-016000 ZT310 PKE buzzer 1
4 1224200-044000 ZT310-X tail skirt middle cover 1
5 1240300-071000 Cuff bushing cushioning rubber
（
φ11×φ16×1
）
4
7 1251100-122093 Non-standard boltM8×16(environmental color) 4
Fig.5 REAR COVER
COMPONENT
Rear mud board assembly 1(lithium battery)
6 1251700-058093
Flanging bushing φ8.2×φ11×4.5
＋
φ16×
1.5(environmental color)
4
PROCEDURE
：
●
Back skirt assembly
Locate the taillight and PKE buzzer
⑶
plug on the left side of the body and unplug it.
Remove the 2 bolts
⑴
and remove the bushing
⑵
.
Remove the two snaps at the indication of the arrow on the middle cover
⑷
and remove
。
Remove the bolt
⑺
and remove the bushing
⑹
and the cushion rubber
⑸
.
Grab the pin on the front of the left skirt and pull it out.
Grab the pin on the front of the right skirt and pull it out.
Remove the rear skirt assembly from the frame by slightly separating the front of the left and right skirts.
Remove the PKE buzzer (3) by heating it back and forth with a heat gun. Clean up the remaining offset.
CAUTION
：
●
The material should be protected during the disassembly process to prevent scratching of the lamp and paint
surface.
●
Do not pull the cable directly.
●
Pull out the nail and pay attention to the direction and strength of the force to prevent damage.
●
When reassembling, check whether there is any pressure on the wire to prevent short circuit when tightening
the bolt.