15
4.3.5 "Lift System” remove from pool mode
The Lift System functi on was designed to facilitate removing the cleaner from the water. It may be acti vated at any ti me,
during or at the end of a cleaning cycle.
• Only acti vate the Lift System functi on if the cleaner is in view.
•
In the app's home screen, select
Lift System
.
•
To guide the cleaner to the desired pool wall, use the
left
or
right
arrow.
•
When the cleaner is against the pool wall, press
Lift System
. The cleaner will start to move to the pool wall and raise
itself to the water line.
•
To stop an acti on in progress, press
Lift System
again.
•
Using the handle, lift the cleaner from the water. At this point, the cleaner will expel a powerful jet of water. It will
then be lighter to lift from the pool.
•
Fully remove the cleaner from the water.
•
Press
(X)
to return to the home screen.
• Do not pull the fl oati ng cable to lift the cleaner and remove it from the water;
use the cleaner’s handle.
4.3.6 Programming or cancelling cleaning cycles
Cleaning cycles may be programmed to repeat.
• You are strongly encouraged to remove and clean the fi lter aft er each cleaning cycle.
•
From the app's home screen, select
Next cycle
or go to
Parameters
and select
Changer ti mers.
• Select the
day
of the week. Only one programme can be set per day.
• Select
the start ti me
for the cleaning cycle.
•
The ti me display can be customised from the
Setti ngs
menu. Simply acti vate or deacti vate the
24h ti me
format
; if deacti vated, the ti me will be displayed in
a.m.
or
p.m.
format.
•
Press
Save
to save the programming or
Cancel
to erase it.
Repeat these steps to program other cleaning cycles.
•
The cleaning cycle durati on may vary depending on the setti ngs selected in the
Cleaning programme
, see
“4.3.3 Confi guring the cleaning program".
•
To delete a programmed cycle, select the
day
programmed and press
Delete programming.
•
Press
(X)
to cancel and return to the home screen.
The next cleaning cycle programmed is displayed on the home screen.
•
The cleaning cycle that will start during programming will be the last cleaning program selected, see
“4.3.3 Confi guring the cleaning program".
Содержание Vortex iQ
Страница 21: ...20 5 5 I Changing the tyres EN ...
