8
©2019 Guangzhou ZHIYUAN Electronics
Date: 2019/01/17
User Manual
V1.00
C
Guangzhou ZHIYUAN Electronics Co., Ltd.
ZDS2000B Series Oscilloscope User Manual
The ZDS2000B Plus Series oscilloscopes are only oscilloscopes are only allowed to be
used in the specified measurement category.
1.4 Instrument Placement
CAUTION
The instrument placement location should meet following conditions:
Do not install the instrument in the place in direct sunlight, near heat sources,
strong magnetic field sources, high voltage equipment or power lines, and where
an excessive amount of soot, steam, dust or corrosive gas is present, and where
there is water, oil or chemical.
The instrument should be placed on a flat, even surface; otherwise the
measurement precision may be impaired.
Good ventilation. In order to ensure good ventilation inside the instrument, there
are cooling holes in real panel to avoid high internal temperature; please make
sure the air inlet and vent of the product keep the air flow freely. When using the
oscilloscope on the work bench, please leave at least 10cm gaps on the top,
back and both sides of instrument.
Protection impairment if used in a manner not specified by the manufacturer.
Not to position the equipment so that it is difficult to operate the disconnecting
device.
Warning
: Inadequate ventilation may cause temperature increase inside the instrument, thereby
causing the damage to product. Please inspect vent and fan constantly to keep the instrument
ventilated.
1.5 Maintenance and Cleaning
Maintenance
Do not place the instrument in a place exposed to direct sunlight for a long time.
Cleaning
Please clean the instrument as follows:
Cut off power supply.
Use a damp but not dripping soft cloth (with a mild detergent or water) to wipe
the dust outside the instrument. When clean LCD screen, be careful not to scuff
the transparent LCD protective screen.
WARNING
Before the product is powered on, make sure that the product is dry to avoid
unnecessary accidents caused by leaving some moisture.
