24
©2019 Guangzhou ZHIYUAN Electronics
Date: 2019/01/17
User Manual
V1.00
C
Guangzhou ZHIYUAN Electronics Co., Ltd.
ZDS2000B Series Oscilloscope User Manual
all kinds of data frame trigger modes can be configured.
CAN-FD
CAN-FD protocol has three data types: CANH, CANL and CAN-DIFF .The
normal Baud rate and FD Baud rate should be set and the start bit triggering and
all kinds of data frame triggering can be configured.
LIN
LIN protocol support LIN1.1 and LIN1.3 version, LIN bus synchronization
interval, synchronous field, specific ID, specific ID + specific data within the
1Mb/s can be triggered.
Flex Ray
Flex Ray has one data line TXD .Flex Ray bus within 20Mb/s can be triggered in
the TSS and frame ID.
USB
USB has two sources, including D+ and D-.
USB2.0 (low speed +full speed) bus output packet, input packet, start packet,
setup packet, DATA0, DATA1, response packet, no response packet, stop
packet, preamble packet ,package synchronization and package terminator
within 20Mb/s can be triggered. Each triggering mode can further specify the
specific information of the corresponding packet, for example, the start packet to
set the expansion parameters and account values, the setup package to set the
expansion parameters, address values and port values.
SD_SPI
SD_SPI has two sources, including clock source and command source.
On the 20Mb/s SD bus (SPI mode), the specific command or specific command
+ parameter can be triggered and decoded.
SD_SD
On the 20Mb/s SD bus (SD mode), the specific command or specific c
parameter can be triggered.
Wiegand
Triggers when the specified OEM, FC, CC segmen ten countered on the
Wiegand bus(26Bit, 39Bit, 44Bit or customized frame format), or data is the
specified value. Supports for masking certain fields as needed.
DS18B20
DS18B20 has one data channel. The temperature resolution of
9,10,11,12bitscan be set for decoding .The start bit, the specified ROM
command and the specified RAM command on the DS18B20 bus can be
triggered.
PS/2
PS/2 has two sources, including clock source and data source.
The start bit and data on the PS/2 bus within 1Mb/s can be triggered, which
support triggering from the host to slave and from the slave to host.
MDIO
MDIO has two sources, including clock source MDC and data source MDI.
Supports triggering for ST segment, OP segment, PHYAD segment, REGAD
segment and DATA segment on the MDIO bus, and they can be decoded in both
LSB and MSB modes.
DALI
DALI has one data source. Triggers for decoding when the specified Forward19,
Forward27, Backward frame en countered on the DALI bus.
