Zirkon zahn M1 MILLING UNIT COMPACT LINE, Руководство по эксплуатации и обслуживанию

Страница: 17 / 52

17
CHAPTER
SAFETY AND RESIDUAL RISKS
ZIRKONZAHN – OPERATION AND MAINTENANCE MANUAL M1 MILLING UNIT COMPACT LINE – VERSION: 13/05/2021
POSSIBLE SOURCES OF DANGER
Possible sources of danger Security measure to be taken
The milling unit has a high dead
weight (see technical data sheet). Risk
of contusions during transport and
installation of the equipment. Wear work safety gloves and safety shoes
when setting up the milling unit.
Components under electrical voltage.
Defective power supply lines.
Only use milling unit with an intact power
supply system (including power cable).
Repairs and replacement of electrical
components must only be carried out by a
SWCNKſGFGNGEVTKEKCP
'OGTIGPE[UJWVFQYPŬVGPUKQPHTGG
Dust emissions. Elaboration generates dust as a result of
the processing. The extraction capacity of
the connected extraction system should be
UWHſEKGPVVQCDUQTDKV
A small deposit of dust in the milling
unit can never be completely excluded.
Therefore, wear respiratory protection and
safety goggles when opening the milling
unit and especially when cleaning it.
9JGPOKNNKPIƀCOOCDNGOCVGTKCNUUWEJ
as resin or wood), an antistatic suction pipe
must be used.
Use of sharp milling tools. In general, only hold milling tools by their
shank, not on their cutting edge.
The wearing of protective gloves is
recommended.
Moving parts. The operation of the milling burs is only
possible with the front plate closed.
Should the front plate be damaged or the
safety switch not work properly (colour
of the light must change when opening),
switch off the milling unit and contact our
customer support immediately.
Danger of contusions caused by the
front plate. The front plate must be closed manually.
$GHQTGENQUKPIOCMGUWTGVJCVſPIGTUQT
objects are not trapped.
+PUWHſEKGPVDGCTKPIECRCEKV[QHVJG
installation surface for the milling unit.
The installation surface must correspond to
VJGTGSWKTGOGPVUURGEKſGFKPVJGVGEJPKECN
data.