Zipp Manufacturing I-BOX, Инструкция по сборке

Страница: 30 / 45

28
Note flat filed for drive dog screw.
Flex shaft assembly complete.
Flex cable prep: Collet
drive engines:
(For square drive type engines, skip to the next
section).
Get the flex cable, drive dog, prop and prop nut.
Put the drive dog on the stub shaft, then the prop.
Engage the drive dog into the prop, and slide this
assembly back until the prop covers the first 2 or 3
threads on the stub shaft. Tighten the drive dog set
screw.
Mark the stub shaft at the front of the drive dog.
Remove the dog and prop.
Measure 3/16 inch back from your line, and file a
flat spot, about 1/8 inch wide and 1/16inch deep.
This is for the set screw. File off any burrs, and put
the drive dog back on, tightening the set screw into
the flat.
Put the prop and prop nut on. Slide the flex cable
into the strut, until the drive dog touches the rear of
the strut. Tape the front of the cable to the bottom
of the boat for now.