802411US v1.27 06.21 BC, BC100-75 Install Instructions
Page 17 of 32
•
Turn ON the water and gas and check for any leaks.
•
Turn the power ON at the outlet and at the side of the Command Center
•
If fitted, ensure the Booster is turned OFF (the Booster is commissioned, later, at section 4.5)
•
Familiarise yourself with the operation of the Faucet, in preparation for use (See User Guide)
•
Follow the Installation instructions below (and review Section C of the User Guide).
•
After commissioning, the system may be customised by selecting further options in Section G -
Settings, within the User Guide.
4.2
-
Filter Flush
Section 4
Commissioning
4.1
-
Select the Language
Initial Commissioning screen
Language selection screen
Boiling Chilled
10:30 Wed 04,Jul 2018
Boiling Chilled
10:30 Wed 04,Jul 2018
Boiling Chilled
10:30 Wed 04,Jul 2018
A new filter cartridge is provided (but NOT fitted), inside the
filter door. Unpack the new filter cartridge and write today’s
date on the label. To install the cartridge, align the key tabs
and insert upwards into the filter head. Turn the cartridge to the
right until it locks in place.
Have a 10 liter (2.6 gallon) bucket or similar container (not
supplied) at the ready to hold a quantity of water that will be
ejected while the Filter Flush Mode is in operation. Open the
filter access door on the front of the HydroTap and the filter
cartridge will be exposed. Located to the rear RHS of the
cartridge is a flush line and the flush line stop cock. Place the
valve end of the flush line into the bucket or container.
Note:
You will need to Press the [Start] [Stop] buttons to start
and stop the filter flush.
1
1
2
NOTE:
For any subsequent filter changes or any operational
procedures, please refer to the HydroTap user guide, located
inside the filter housing access door.
OPEN
CLOSED
Stop cock operation
1. Turn the flush line stop cock ON (See diagram).
2. Press [Start] and allow at least 10 liters (2.6 gallons) of
water to flush through the filter.
3. The product details will be displayed in the screen.
4. Once the filter flush is finished, Turn the stop cock OFF
then press [Stop] to end filter flush mode.
