802411US v1.27 06.21 BC, BC100-75 Install Instructions
Page 15 of 32
John Guest
fittings
Be careful when cutting the poly tube so that there are no rough edges and that the tube is not distorted.
1. Use a sharp knife to ensure the tube has a clean, straight edge. Do not cut at an angle.
2. Remove any swarf or unwanted material.
3. Push the tube into the John Guest fitting making sure all connections to the John Guest fittings are
pushed in past the O-ring to full depth, at least 15mm
(⅝”)
.
4. Check for a good joint by pulling back on the tube. If the tube comes out of the fitting, repeat the
above step.
5. To remove the tube, press the collet into the fitting and at the same time pull back on the tube.
3.3
Hose and tube fitting
•
Remove all caps from the top of the Command Center (except the mixer caps)
•
Only remove the mixer caps if a mixer faucet is to be fitted.
•
Fit the foam insulation to the Blue and to the White tubes after trimming them to length
•
Install the mains water braided hoses to the Command Center before locating the unit in place.
• Do not overtighten
Con Strainer
90° Bend end
of Braided Hose
To HydroTap
Command Centre
Braided hose for
Mains Water Supply
From Mains
Water Supply
Installation Instructions
